Miter Joint
評価版
OS:
言語:
説明
In the furniture industry, carpentry, woodwork, and exhibitions, the connection of two sheet parts "Miter joint" is often used. This connection is used when it is necessary to saw off the edges of the parts not at a right angle, but at 45 degrees so that the parts can be glued into a right angle. The connection is not difficult to model using regular Autodesk® AutoCAD® tools, but you need to either drag the edges of two solids, or glue two rectangular parts together with the _Union command, and then cut them with the _Slice command, defining the cutting plane at three points. To save you time on cutting, I came up with a simple Miter command. Instead of a dozen clicks, it is enough for you to click once on any linear edge of the solid, and the program itself will measure the angle between adjacent surfaces, and build a section plane, and call _slice itself.
Program features
- No settings are required.
- The edge through which the cut will pass can be arbitrarily located in space.
- The angle between the parts is not necessarily straight (90°). The program will build a bisector of any angle.
- Surfaces adjacent to the edge do not have to be flat at all - these may be the surfaces of a cylinder or cone. The angle will be measured tangentially.
- You can select an edge before calling the Miter command, or after calling.
- Command perfectly complements the AVC_Slice command (ASL = VO). Select immediately a couple of solid surfaces via Ctrl, peel them together, and cut for miter joint.
- The program runs in a loop until you press Esc. You can cut as many details as you like at a time.
Regardless of the AutoCAD language, you can switch the plugin's dialogs and messages into the following languages: English, German, Italian, Russian, and Chinese.
体験版の説明
To run the plugin, you will have to register account and top up your account balance or receiving bonuses.
Then you can activate one of the licenses:
- Annual license - 10 Euro.
- Unlimited license - 50 Euro. Free updates for 1 year.
- The trial period is 20 days.
Очень удобный плагин, при работе с сложными по форме изделиями, где много ломаных поверхностей, просто не заменим. Время работы сокращает в разы и бережет нервную систему) Большая благодарность разработчику.
Спасибо!